The following outlines the selection process for a plug-in electromagnetic relay, using the cooling fan relay of a pure electric light truck's drive system as an example:
1. Select the relay model based on load type and magnitude
Vehicle electrical loads are generally categorized as resistive, inductive, or capacitive. For inductive and capacitive loads, one must consider not only the continuous operating current but also the magnitude of pulse currents and inrush currents occurring at the moment of contact closure. The continuous operating current must be lower than the relay's rated maximum continuous contact current, while the peak values of pulse and inrush currents must remain below the relay's rated maximum switching current.
2. Determine the relay operating voltage
Select the relay's operating voltage based on the vehicle's electrical system voltage (e.g., commercial vehicles typically use 12V or 24V platforms); the relay coil voltage must match the vehicle's system voltage. Contact gaps in relays designed for 24V loads are significantly wider than those for 12V loads; using a 12V-rated relay to switch a 24V load may result in an inability to extinguish the arc, leading to relay burnout.
3. Determine the contact configuration
Select a contact configuration-such as Normally Open (NO) or Changeover (CO)-based on the vehicle's electrical schematic. In this specific pure electric light truck, the drive system cooling fan relay is controlled by the Vehicle Control Unit (VCU), which triggers contact closure based on threshold values derived from the motor controller's IGBT temperature and the drive motor temperature; therefore, a Normally Open configuration is selected.
4. Select the packaging type based on the operating environment
Plug-in electromagnetic relays in vehicles are typically housed in relay boxes. Dust-proof cover types are commonly used, whereas sealed (plastic-encapsulated) types are selected when waterproofing is required; in sealed types, the base, terminals, and housing are bonded with sealant, fully enclosing the internal components. Since the cooling fan relay for this vehicle model is located within the chassis fuse box, a dust-proof cover type is suitable.
5. Selecting Contact Material
For a given relay model, the types or ranges of loads suitable for different contact materials vary slightly. AgSnO2 (silver-tin oxide) is a commonly used contact material; it offers excellent resistance to welding and minimal material transfer, making it suitable for resistive, lamp, inductive, and capacitive loads. Consequently, AgSnO2 is typically the default choice for contact material when selecting a relay.
6. Connecting a Transient Suppression Component in Parallel Across the Coil
Since a relay coil acts as an inductive load, disconnecting the coil circuit causes the energy stored in the coil to generate an overvoltage across the switching contacts. The peak of this overvoltage can reach several kilovolts; the faster the switching-off speed, the higher the peak voltage. If the semiconductor component controlling the coil circuit lacks sufficient voltage withstand capability, it is highly likely to suffer dielectric breakdown and fail. Furthermore, this reverse peak voltage can propagate along power lines, causing severe electromagnetic interference.
Connecting a transient suppression component in parallel across the coil creates a conductive loop after the control switch opens, effectively reducing the reverse peak voltage generated upon disconnection. However, this also slows the decay of the coil current, thereby delaying the return of the relay's moving contact to the normally closed position and extending the operation time, which ultimately reduces the relay's service life. While a transient suppression diode connected in parallel across the coil offers the best suppression of reverse peak voltage, it also has the greatest negative impact on the relay's performance; therefore, it is generally not recommended. Instead, a transient suppression resistor is typically used to mitigate reverse peak voltage. In this specific case, a 680Ω transient suppression resistor is connected in parallel across the relay coil to reduce conducted interference caused by the relay.
